The Raspberry Pi camera not detected issue usually occurs if the device is not enabled from the Raspi-config section. If the issue persists, you may have a faulty camera unit that requires replacement.Test the camera to see if it is working.For testing, connect the camera to another Raspberry Pi device and connect it to your PC.If the issue persists, and you have made sure the camera is enabled in the raspi-config file as well the camera is seated correctly, check if the camera has hardware faults.Exit Raspi-config and check if the issue with your camera is resolved.Next, go to Raspi-config > Interfacing Options and then enable I2C.Select Camera and follow the prompt to enable the camera.Go to Raspi-config and open Interfacing Options.For the camera to work, you must enable it from the Raspi-config > Interfacing options.

If you want to continue making a time-lapse video with these images, install VideoPad Editor and follow the steps shown below in the screenshots.Home › Software › Developer Tools › Raspberry Pi camera not detected $ watch ls How to Create a Time-lapse Video With VideoPad Editor For checking the current photos in the directory, type this command: Thatâs it! Now Raspberry Pi will start capturing images at 1fps. Once the file is closed, you will see the message âcrontab: installing new crontabâ on your terminal screen. This command allows for the Raspberry Pi to start capturing images with a speed of 1fps.Īfter adding the line, save and close the file. * * * * * sh /home/pi/timelapse/camera.sh 2>&1 Next, select option 2 nanoOS and add the following line at the end of this page: In the terminal, type the following command: We now need to run this script on boot and allow it to repeat itself over X minutes, which will help us to capture the images. If the command does not fail, then you will find an image on the / home/pi/timelapse directory with your current date and time. If you face any errors after entering this command, double-check the bash script.

Pi zero camera setup